Desert Online General Trading LLC
Dubai, United Arab Emirates
Desert Online General Trading LLC
Dubai, United Arab Emirates
CNC Shield Board: Latest Arduino CNC Shield Version 3.0 GRBL 0.9 compatible 4-Axis support (X, Y, Z , A-Can duplicate X,Y,Z or do a full 4th axis with custom firmware using pins D12 and D13) 2 x End stops for each axis (6 in total) Coolant enable Compatible with A4988 or DRV8825 stepper driver Runs on 12-36V DC Arduino UNO R3 Board: MCU: ATmega328 USB interface: ATmega16U2 Operating voltage: 5V Digital I/O pins: 14 (including 6 with PWM capability) Analog input pins: 6 I-I/O pin output current: 40mA max 3.3V output current: 150mA max Flash memory: 32 kB (0.5kB used by bootloader - included) Static RAM (SRAM): 2 kB EEPROM: 1 kB Clock speed: 16MHz A4988 Stepper Motor Driver: A4988 Stepper Motor Driver Board is a breakout board for Allegro's A4988 DMOS Micro stepping Driver with Translator and Overcurrent Protection; Low RDS (On) Output : Automatic current decay mode detection / selection Mix with slow current decay modes Synchronous rectification for low power dissipation Internal UVLO Crossover-current protection 3.3 and 5 V compatible logic supply Thermal shutdown circuitry Ground fault protection Load short-circuit protection Five selectable step modes: full, 1/2, 1/4, 1/8 and 1/16 Warning: Connecting or disconnecting a stepper motor while the driver is powered can destroy the driver. (More generally, rewiring anything while it is powered is asking for trouble). Package Contents: 1 x CNC Shield Board 1 x UNO R3 Board for Arduino 4 x A4988 Stepper Motor Driver 4 x Heat Sink
R**H
My second one.
Runs great with GRBL as an A drive 4th axis,
L**S
Five Stars
As described
S**N
Good kit.
Very good kit, however I had some problems setting it up. Those problems were due to wrong firmware on my computer though, so this kit is not at fault. Everything pictured was nicely packed in individual static bags for: 4 A49888 Stepper motor drivers, 1 CNC shield V3.0, One Arduino uno clone, and one 2 ft usb cable. Jumpers needed for operation are NOT included.
A**R
Five Stars
Every thing worked great
A**R
COUNTERFEIT PRODUCT!!!
ATTENTION: This is a counterfeit Arduino UNO board. The product description clearly states “Arduino UNO R3 Board.” However, what I received was a knock-off counterfeit board. If I order and pay for an Arduino brand board, I want to receive an Arduino brand board.
R**8
Garbage!! Don't waste your time!
Extremely frustrated with the CNC Sheild. Never got this to work after spending a long day debugging and reinstalling grbl multiple times.
M**R
Does not support GRBL 0.9
I just bought 6 of these to teach a class with. 1st - They are not GRBL 0.9 compatible. They are GRBL 0.8 compatible. The difference is they swapped pin 11 /12. This means if you run the latest GRBL(1.1 at the time of writing this) the Z axis will not work and the spindle enable / laser enable pin Will not work.
M**O
Exactamente lo que ofrecen, excelente kit CNC
Recibido en perfectas condiciones
Trustpilot
2 weeks ago
1 month ago
