SSBF010 Stainless Steel Bulkhead Fitting (Female 3/4" NPT/FIP, Left Handed Nut, w/Step Gasket) (2 pack)

Used these to put drains in two barrel halves for beer baths, Worked like a charm,

Good solution to convert my Type 1 range hood to a Type 2 condensate hood for my home brewery. I needed a spigot to drain the liquid condensate from the rear pan. Its got threads on the outside and inside. I added an MNPT to barb fitting which goes to a bucket at the end of a boil.

Well made. Compact and leakproof.

They were great! I used them to create ports on regular steel trash cans. Then I added stainless steel ball valves. They turn a clean steel barrel into excellent rain catching/dispensing container.

I'm planning to use these for the inlet valves on an ugly drum smoker, so sealing fluid in isn't critical. I built rain barrels previously and these bulkhead fittings would have made it easier. I think it's a great deal, and the workmanship was fine. You need to know the outside thread is reversed, so you can't put the flush end out or else when you tighten the inside pipe/fitting/hose bib it will loosen up on you.

These little beauties solved my problem of how to make a Rain Barrel from a garbage can. No more than five minutes to install. Had our first big rain last night. Now I have 30 gallons of rain water to water the plants,

I used these to connect to a pump through the wall of a stainless steel drum. For the price I thought they would be cheap. They were better than expected and I plan to buy more.

The only issue I had was the low quality surface finish and them being shipped with cheap silicone seals. The seal holds water in but I’d replace it with something else like a slightly thicker, same diameter buna, nitrile, etc. seal and you’ll be good to go. Especially when using with various chemicals and hot liquids. I would carefully question the lifespan of the stock seals. The threads on mine were higher quality but the faces of them were scratched up. Higher quality metal and threading with lower quality parting off causing poor top / front face surface finish. Of course, as with anything made in China, your results may vary.

Good quality & arrived ahead of schedule.