Aluminum 8C Mining Rig Case Without Fans, Stackable Open Air Frame Miner Case for ETH/ETC/ZCash/Cryptocurrency

These are always on max speed type fans unless you have a molex controller or molex to 3 pin converters and fan controllers. The price is awesome with more performance for the least cost. My motherboard doesn't allow 100% always on with my fans , and I got tired of allowing my MSI gaming motherboard to control my fans at 80% at 40C then at 45C be at 100% , I daisy chained them at two locations not putting them all on the same daisy chain and these fans are simplicity with pure performance , loud but that is not a concern of mine. My PC temps are 10C lower with these fans than with the hyper 212 fans, and more airflow than with basic flashy case fans . I am very satisfied :D

The Veddha mining case is simply amazing, for the people who had difficulty assembling please pay attention to all of the holes on each individual piece and seperate all pieces in advance. That would make it a whole lot easier to install.

For the price of it paid and the super fast shipping I wanted to give it at least four stars.The actual frame is kind of flimsy, lack of directions, one missing bolt for the top rail, and two broken fan Molex adapters after initial unboxing and assembling.But aside from all of that; it is a decent starter frame and maybe I am a little biased towards the essential sturdiness and practicality of the design for the frame.You get what you pay for; but definitely great for a smaller rig build. Due to the flimsiness of this frame alone, I wouldn’t trust to stack. Going to give this frame to a friend and just use the dimensions to build a frame of my own.

I would suggest to sit down 5 minutes and look over the instructions, should be able to assemble in about 1 hour. Good quality frame. The fans can be tricky, leave the bolts loose and bolt it to frame then tighten them. Watch the holes placement for the motherboard and the square they keep showing is the harddrive. For the price it would be hard to make anything close in a diy. Best tip I could give is build on a flat surface and leave the bolts lose until you are confident everything is square and placed right.

These rigs tend to be fairly similar; I have built 9 so far, and this particular rig was a bit better and a bit higher quality than most others I have built. Decent instructions, decent quality; everything fit correctly and I got all the necessary parts, so overall, it's a thumbs up from me.

Nice quality and design. No instructions but easy to build from the pics. Good for full length video cards that do not have a VGA connector protruding. If you have VGA connectors like mine that interfere with the fans, then the fans have to be relocated the outside of the frame and only held with a couple screws each. It works.

This mining frame is not easy to assemble (assume 6-8 hours for full assembly) but once you do have it all together it looks great and it's sturdy enough to lift and move the whole rig around if you need to.

Biggest problem is it came missing the PSU mounting bracket, I contacted amazon and the seller with no luck so far, I may have to fabricate a bracket myself. This took a bit of time to put together, the directions were almost useless, I needed to make some mods to the mounting and cut some holes to pass cables thru, the frame feels sturdy, when everything is together is doesn’t wiggle or move. It has good spacing between the GPUs and comes with the fans so they stay cool even under load. I took some pictures of the whole frame and the mods i needed to make, its a good frame but the seller has a lot to work on.