Mcbazel SL/SR Sync Button Flex Cable For NS Switch Joy-Con (Set)(Not for NS2)

Better quality than the more expensive ones, I had issues with another more expensive one being faulty and it had been an absolute pain to install so I bought this one and it worked perfectly and was easier to install as it was almost identical to the official ones

Same as stock part, worked flawlessly

Had previously ordered a set of tools, taken controllers apart and worked out the problem. Ordered these that came within 2 days. Watched a video to confirm what to do. Left and Right are slightly different so worth doing this. Was quick and easy to replace the board. A bit fiddly with the connector but took my time and important to loosen battery compartment so you can get at connector better. Both working and being used again in no time. Can say how long they will last as inherent problem in the overall design. The cable has to be bent to fit and over time pressure on the controls outside bends the cable inside more to the point where the wires inside the cable break. Beware when you take it apart the cable straightens and the SL SR buttons can work because the broken wires inside touch and make a connection. So you may think it's not the SL SR board but if you bend the cable slightly and test you will see they stop working. Hopefully these will be a bit more robust and not break inside again.

A bit fiddly to fit bit that is not the fault of the board. I put them in the official joy con's. Worked no problem.

My joycon would not operate horizontally, only in vertical mode. I was then suggested by someone to replace the flex cable and after taking it apart and reassembling it fixed the issue. So highly recommend this repair for a bad flex cable.

Everything in the best order, fast shipping, good communication and good price :)

Works as expected. With the help of a Youtube video easily fixed the broken connection resulting in no lights and shoulder buttons not working on the joy con….with a little bit of effort saved £££££….would recommend

My right Joycon LED lights stopped working a while back but I ignored it as it didn't stop functionality until I tried using it as secondary controller and it wouldn't pair (The SL & SR buttons required to sync are all part of this board). Took it apart and tried adjusting the cable and the lights came one when bending the ribbon cable at a certain position but I couldn't get it stick so the fault must've been somewhere within.Swapped this one in, and so far it works as intended and the green LEDS look identical to the original.If you're doing this repair yourself you will need a Y00 and PH000 screwdriver and be very careful not to stress the other cables in the controller. It's a shame joycons are plagued with issues but at least they're pretty easy to fix.

Replaces the original ribbon cable which failed and caused the buttons to not work.

Funciona perfectamente. El que tenia original el control empezo a fallar hasta que murio. Este remplazo conecta de inmediato a diferencia del original y es muy facil remplazarlo cuando ya tienes algo de experiencia arreglando tus joycon.

1 piastrina per joycon destro e uno sinistro, facili da sostituire, bisogna esser delicati

Fácil de reemplazar y funciona según lo esperado. Repetiría compra sin dudarlo.

The media could not be loaded.  Ce produit m’a agréablement surpris.Le câble est bien conçu, semblable à celui d'origine. Il s’adapte parfaitement aux manettes Joy-Con de ma Nintendo Switch.L’installation est minutieuse mais simple. Plusieurs tutos sont disponibles sur internet.Le remplacement se fait en quelques minutes.Depuis que j’ai installé ce câble, mes Joy-Con fonctionnent à merveille. Les boutons SL et SR sont réactifs, et je n’ai plus rencontré de problèmes de synchronisation.Je suis ravi d’avoir trouvé une solution économique pour réparer mes manettes.