Specification: Running current:30A(Output: Continuous 30A, Burst 40A up to 10 Secs.) Input Voltage: DC 6-16.8V(2-5S LiPo) BEC: 5V 2amp. Size: 46mm (L) * 26mm (W) * 11mm (H). Weight: 23g With SimonK updated firmware for multicopter Features: Drive tube and high-power Mos, and Mos tube plus a separate heat sink, Extreme low output resistance of the PCB(printed circuit board),super current endurance. The power input uses extreme low output resistance greatly enhance the power stability, and has the protective effect on the battery. Safety electrical function: when the power is turned on, regardless of the throttle stick in any position does not start the motor immediately, to avoid personal injury. Separately voltage regulator IC for microprocessor. providing good anti-jamming capability. Supported motor speed (Maximum): 210000 RPM (2 poles), 70000 RPM (6 poles), 35000 RPM (12 poles). Using Simon K’s a dedicated multi-copter program tgy_debug, and the master chip with high stability crystal oscillator, making the motor control to more precise. THROTTLE RANGE SETTING This setting is for first time using or a new transmitter is being used. Switch on transmitter, push the rocker to the top and connect to ESC power. Brushless motor emits a tone which shows that power is connected successfully. Brushless motor emits beep….beep…which means throttle is at the top. Move the rocker to the bottom within 2s, brushless motor emit beep….beep….beep….which means throttle is at the bottom. Wait for about 5s, brushless motor emits beep tone indicates that sure setting PROGRAM CARD SETTING Program the ESC with your transmitter(4 steps) Enter program mode Select programmable items Set item＇s value (Programmable value) Exit program mode Enter program mode Switch on transmitter, move throttle stick to top , connect the battery pack to ESC Wait for 2 seconds, the motor should emit special tone like “beep-beep-＂
Trustpilot
1 day ago
2 months ago
