2-Pack Right Left L/R Button Micro Switch Button Replacement for Nintendo Switch Joy-Con Controller

Aún no los pruebo pero son tal cual están publicados

Which is good because I just need to take it out from the set and put it in the older one.

If you dont know what you're doing install can be a pain since they are so small. Direct heat on the contact with good Flux helps. They work great in my sons switch lite.

They fit perfectly. Soldering these takes some skill so don’t buy them if you don’t have someone experienced enough not to mess up your joy cons.

I'm not sure why the review has a noise level option other than possibly the clicking which is fine enough. These are easy to install if you know your way around a heat gun or soldering iron, but a little expensivenand be sure to check if they work before reassembling some can come faulty

You must have micro soldering skill to perform this job,after that the part work as intended just dont too much heat.

Soldering skills required

Upon receiving I figured it would be easy to install this where the micro switch before was, had broken off while trying to change the shell of the joy con. Boy was I wrong! Not only was it almost impossible, but after accident dropping the switch it was almost impossible to find. Also I can’t tell if the board from the original micro switch falling off is completely damaged now but it sure looks like it as now there is nothing to solder the new micro switch to. I did as much research as humanly possible trying to figure out the best route to take to fix this but if looks like I’m out of luck. Nothing wrong with the company, they came through on their end 5 stars for them, but 0 stars for the crap replacement part. Don’t even try it if you aren’t 100% sure what you’re doing. You’re better off just buying a new set of joy cons.