12V Blue LED Push Button Switch Waterproof Toggle with 4-Wire Connector Kit Multi-Purpose for Car Modification (Start Switch)

The switch works well. I was reading some comments about accessories being dimmer and even a fire. You cannot run anything more than 1-2A through a switch. You must isolate the high amperage circuit with a relay.If you have a 30A light with thick wire and you expect 30A to flow through this switch reliably, you will start a fire.Relays have 2 circuits. One is from the battery to your accessory (usually high amperage positive). The relay functions as a switch.Whether the relay is on or off can be safely controlled with this dash accessory switch.Really, you should fuse both inputs to the switch - your circuit and to the light on the switch with 1A fuses.FYI, fits toyota dash blanks well.

Great switch as it fits perfect for my Toyota and sits clean in oem slot. Not difficult to wire a device to it. You don’t need to be an automotive electrician just need patience and common sense

Looks great, very very close to OEM. I used this on a 2013 Camry because I wired in a 100% independent fog light circuit meaning I can turn them on independent of the headlights. Fitment is great. I love it. I do wish the blue indicator light (switch on) was a bit more dim for night time driving, but I'm hypersensitive to interior lights at night. I am going to try to dim it with a piece of tinted overlay, sharpie, or something else. I still need to figure that out. But, again, I love this and am very happy I found it!Update: The light is extremely bright at night. It's very very distracting at night, and dangerous because so, and passengers have commented the same. I was able to dim it by using a combination of spray tint and sharpie to color in the section of the button that the light passes through and it is now acceptable. I have uploaded a picture at night after doing this. I also changed the location of the button to reduce the glare on my side window.

These fit perfectly in my Tundra and I haven’t had any issues with them.

The switch fit in the factory slot and worked fine for a while but it broke within a year. I used it for an auxilary lighting switch so it wasn't used very often. The lights turn on when I push it in, but the button won't "click" and stay on.

I added the switch for the boss plow that I put on my 2022 Toyota Tacoma TRD. I needed to pick one with a generic indicator. This is used to switch between the plow lights and the truck lights. The switch that comes with the plow kit is just double-sided taped to the dash This looks much better. I recommend.

I hardwired some lights to my battery and found that when I added this switch, the lights were dimmer than when I had it directly wired. I assume the blue led in the switch draws quite a bit of power before powering your accessories.

Switch fits well, works well. Used it to ground my Alpine headunit, disabling the "not-while-driving" lockout. Would have been nice to customize the label to say "radio", but I'm happy with the results.