EnttecODE Mk3 70407 POE 2 Universe Dual DMX / RDM Ethernet Converter Interface

Works great with ETC EOS

I'm using this to control some Nantec LED tubes over DMX. Works perfectly using Enttec's NMU software, my own custom artnet software, or (I'm sure) any number of other artnet implementations. Behaves as you would expect - gets an IP address via DHCP (by default) and requires zero configuration.

I just want to let people know if you are having an issue with your lights dropping dmx signal every 120 seconds make sure you turn off RDM mode on on the DMX universe you are having the issue. I spent a few hours trying to debug my friends lighting system to track this down. Enttec mentions on page 5 of the Enttec ODE MK3 manual: “Enttec recommends disabling RDM if your fixtures do not require it. Some older fixtures that support the DMX 1990 Specification can behave erratically when RDM packets are on the DMX line. “ After I disabled RDM in the Enttec ODE setup configuration everything worked flawlessly.