Vehicle Fitment: Honda CR-V 2011 2010 2009 2008 2007
�**�
I would recommend a different brand/model
The actuator did not come with the rod to the handle. Had to use the old one. It would not stay on when reinstalling the actuator into the door. The rod kept falling off. After the install, the door does not open with either handle (inside/outside). This is the fourth install, the other three went more smooth than this one. I purchased a different model for the other three doors. I would purchase a different model next time.
P**K
Was easy to install
Was easy to install, relatively. I gave it 4 out of 5 stars because it didn't come pre greased. I had previously purchased some silicon grease which I used on this component. Put grease in all the areas where it should have been. Other than that, all the bolt holes lined up. Everythng works perfectly. No complaints. It also didn't have the plastic cover or screws the covers where the open and locking cables connect. It was necessary to reuse from the old unit. But I'm not giving it 4 stars for that. I'd rather reuse the old and have the price be lower.
S**W
So far so good
Installation was easy enough and the new part works fine so far. I do wish they included more of the padding that was present on the one installed by Honda. It's very difficult to transfer without damaging it. Other than that, no complaints yet.
P**L
Misleading
Wrong part even though described as such for our car model
E**H
Installed and works.
Fits perfectly in a 2007 Honda CRV, rear right door. Should be noted that you'll have to salvage some parts from the existing actuator to install this new one. Not too hard, but not for the faint of heart.
M**R
Solved the noise problem...
Worked like a charm. Needs bit extra effort to install it. Worth it.
R**N
Manufacturing defect/missing a thread
I do not recommend this product and here's why:1- They don't tell you that you need to recycle the cover and the lever from the old actuator.2-Once you remove the tab that holds the lever It becomes loose and ineffective. I had to pull a Macgyver to make it hold.3-The metal where it's screwed to the door was missing a thread which I had to recycle from the old actuator.
Trustpilot
5 days ago
2 weeks ago
