POLARH7 Bluetooth Smart Heart Rate Sensor

I read some of the bad reviews about this and was a little worried but ordered it anyways because overall the rating was around 4/5. And all I can say is that it was a great purchase and I should have never hesitated. This is my first HRM and first Polar product. I read a page or two in the manual which is basically all I needed. It said to turn on my Bluetooth and then open the apps I wanted to use the HRM with. First I downloaded and opened the Polar app. I told it to connect to the HRM and it connected but then a popup said "connection lost" About 30 more dialog boxes of "connection lost" came up over the next few seconds. Finally behind all of those I saw that it had successfully paired with the app. I had to click "ok" on all the "connection lost" boxes but I finally got back to the app and saw my heart rate being displayed. Yay! This is the only time the sensor/app had connection "jitters." All the additional times I've used the HRM with the Polar app or any other fitness apps there have been no issues at all. I only had to pair it once, not every time I use it like other users have reported. I just put on the monitor, turn on bluetooth on my phone, open the app and I'm good to go.I tested pairing it with Runtastic and Wahoo fitness apps; both picked up the sensor just fine, no issues. I was afraid that I'd have to pay money to "upgrade" the Polar app like other people have said they had to do, but honestly for HR monitoring the "free" version is awesome. It shows your current heart rate, the zone you're in, your average HR and max HR and you can display these a couple different ways depending on what is important to you. A tap on the screen lets you change the display on the fly. At the end of the workout it tells you how your time in a zone is affecting your fitness. Also you can sync it with the free Polar Flow website, this allows you to keep track of all your training. Currently I'm using the Polar app along side the Nike Running app. Even though the Polar app does GPS tracking/mapping, timing, etc I use the Nike app because all my old runs are on there. But having both open at the same time and with both using GPS is a non-issue, surprisingly it works great! So if you want to use the Polar app for the heart rate only and keep your old fitness app that is not a problem.I had no issues with dropout/spikes in the heart data and I barely used a few drops of water on the conductive strap as it said in the manual. I have not had any battery issues like other people reported. I think they forgot to unclip it from the strap when they were done working out and as a result drained the battery. It uses a CR 2025 button style battery that is user replaceable. The manual states that it has a 200 hour battery life. Also another reviewer said that there must be a problem with these because amazon stopped selling them for a short while. I looked at the used section and saw about six "amazon warehouse deals." They all had minor cosmetic issues I believe. I think the problem was that amazon was sending these in padded envelopes and they'd been mangled and returned. Amazon started selling them again this week which is when I ordered mine. It came in a sturdy box and arrived in perfect condition.All in all this is an awesome piece of tech that is easy to setup and does exactly what it promises. The Polar app is great for HR monitoring even without paying for the special "training" upgrades. I've only had this unit for about a week but I love it and have used it during multiple runs without any issues. I'll update this review and report how it's working out after a few weeks. I'm sure it will be performing great. And if you have any questions just comment and I'll try to answer them if I can. If you found this review helpful please click the button.

Both my husband and I use these with the Polar FT7 watch for a wrist display we can check during runs and Runkeeper for data tracking, and we love them.I have tachycardia (POTS) and it's important for me to both exercise frequently and monitor my heart rate while doing so, to make sure it doesn't get too high - even on meds and other treatment, it's easy for me to exceed 80% max HR in the first minute or two of a run without pushing myself much. The Polar sensors have been great for this - they're very reliable. It helps immensely to be able to tell when I'm tired because my POTS symptoms are worse versus when I'm simply tired.Also, *if* you use a Polar wrist display or the Polar Beat app (more on that below), Polar uses a very accurate algorithm to calculate calories burned based on heart rate (plus age, weight, height, and gender). This is great when I'm counting calories for weight loss.I also love that the sensor detaches when you're not using it, so the battery doesn't drain as fast.One of my few complaints is that my husband's monitor seems to be more prone to losing signal or showing a clearly incorrect heart rate (very high or very low) than mine is (although mine does that occasionally). This may be a problem with the watch (apps don't always pick up the same inconsistencies). I've also had it happen when the band wasn't tight enough, or the battery was close to dying - and I suspect my husband's chest hair has something to do with his more frequent inconsistencies. None of this is a big enough deal to drop a star, especially compared to previous monitors I've used.Watch Pairing: It pairs easily with the FT7 watch; we'd both been using those with the included non-bluetooth sensors, but the watches picked up the new sensors within 30 seconds. We didn't need any special pairing procedures; the watches picked up the signal on their own - and as far as we can tell, they don't get mixed up even when we're running side by side.Phone Pairing (Android): The important thing to remember here is that you don't pair the sensor with the *phone*, but with the *app*. If you go into the Bluetooth pairing settings in your phone, as you would to pair a headset, it won't find a signal for the heart monitor. This is normal. Instead, make sure Bluetooth is on, go into the app you want to use, and check the Settings. Most third party apps have a setting you can turn on to use a heart rate sensor. If I remember correctly, MapMyFitness handled both that and sensor pairing in the Settings when I used it; RunKeeper handles pairing from the map screen (turning on the sensor setting adds a gray heart in the bottom right corner of the map, which bounces when it detects an unpaired sensor and turns red and beats when it's reading your HR). Check the FAQ on the app's website or do a search if you're not sure.Apps (Android):- Polar Beat (Polar's app) is okay for stationary or studio workouts, but just okay. It does give you a nice HR chart and that lovely accurate calorie count that Polar is so good at. However, you'll want to keep it on your body if you're moving around a lot, because this app loses signal very easily if you get your body in between the sensor and the phone. For outdoor workouts, there are much better free apps available; Polar Beat would frequently fail to map my run at all, or stop somewhere in the middle when it lost GPS signal, and its distance measurements weren't particularly accurate. I haven't used it for runs since March 2015, so this may have changed, but I'm not holding my breath.- Third Party: I haven't found an app yet that doesn't pair easily with this, since Polar is the standard in heart monitors. I'm a fan of Runkeeper since it gives you access to your heart rate charts without a subscription, but that's personal preference. I've also easily paired it with MapMyFitness, Endomondo, some random app that's supposed to calculate your "morning readiness" from heart rate, and probably some other workout apps I'm forgetting about. Take your pick - most of them have pairing instructions on their websites if you need them.- Multiple App Pairing: You can use the monitor with multiple apps simultaneously IF the apps allow - some don't. For example, I was able to use it with MapMyFitness and Polar Beat (for accurate calorie count) at the same time without problems; Runkeeper, however, won't even detect the monitor if another app that's running is already using it. For best results, use the window cascade feature to look at what you have running in the background, and close everything that connects to the monitor if you don't need it. However, there's no problem with having multiple apps installed and paired with it as long as they're not all running; you don't have to re-pair each time you switch apps.For reference, both my husband and I have HTC One M8 phones.Multiple Devices on Signal: I've had no problems with the monitor transmitting to the phone and watch at the same time, nor with it sharing the phone's bluetooth signal with headphones.Random tips: If you can't get your phone to pick up the signal, do the usual (reboot, close and restart app, turn Bluetooth off/on). Then check to make sure the strap is snug, especially across the front of the chest, and make sure the sensor is snapped in securely. You can wet the sensor area of the inside of the strap (the vinyl-like part) with water (or, if that's not enough, with salt water or electroconductive gel) if you're still having problems. After that, check the battery. I also find that sometimes the watch, if you have one, is a more reliable test of whether it's working than the phone is.Changing the Battery: Pretty straightforward DIY. I've found it's easiest to use a narrow key ring to turn the battery cover, and make sure to *pay attention* to how the battery cover is oriented in the "loose" position before you remove it, because it's really hard to loosen it again if you replace it in the wrong position and tighten it, and it's not water/sweatproof unless it's seated right. It fits tight, but I had no trouble with it even though I'm sometimes not strong enough to open sealed jars.In summation, this is awesome and I love it. Mine has been working fine for almost a year with one battery change, my husband's for 7+ months. We'll see how long the fresh batteries last.