arger for vehicles that don’t have access to a mains power supply. Its dual

input capability means it can draw power from solar and wind sources, in parallel to the alternator.

The D250SE is a fully automatic, 5 step charger that supplies up to 20A of power to charge, condition and maintain any 12V lead acid service battery from 40-300Ah, including Wet, MF, Gel, AGM. EFB and Ca/Ca.

The D250SE uses patented technology so it’s safe for you and your vehicle’s electronics. It’s also IP65 classified (splash and dust proof, and suitable for outdoor use) and comes with a 2-year warranty.

You will be supplied with everything you need

1 x CTEK D250SE 20amp Charger
4mtrs 10mm² 70amp Red Battery Cable
2mtrs 10mm² 70amp Black Battery Cable
5mtrs 1.5mm² 15amp Red optional ignition cable
1 x Pair 8mm Post Type Battery Terminals
2 x Midi Fuse Holders + 4 x 30amp Midi Fuses
1 x Pack Terminals + Heat Shrink
10 x Cable tie bases
15 x cable ties 150mm
15 X 8x3/4 screws + 3mm HSS drill bit
2 x adhesive pads
2mtrs protective conduit to suit 10mm² cable
Wiring diagram

FEATURES
5 step charging from smart and conventional alternators and DC sources, such as solar and wind
Automatic battery separator works without the need for diodes or VSR relays
Selectable AGM mode for AGM batteries
Parallel input from both alternator and solar panel
Solar panel regulator with Maximum Power Point Tracking (MPPT)
Starter battery maintenance charging when your service battery is fully charged

40:Ta1a,