Longruner 7 inch Raspberry Pi Touch Screen Case Holder for Raspberry Pi 3 2 Model B and RPi 1 B+ A BB Black PC Various Systems LSC7B-1

Good product and fits my 7” monitor.

It's been servicable but beware, it does NOT fit every 7" screen. You may need to dremel for your particular screen in order for everything on your Raspberry Pi to fit. Check your board before purchasing.

There are no direction whatsoever. That being said, there are picture on here that you can figure it out. It's not that hard. It didn't fit my screen but it was easy to cut for an exact fit. The screws are microscopic, so be careful, don't lose them.

I'm not a fan. They laser cut the acrylic with paper taped on and leave it taped on for shipping. I don't think it's to protect it, though; it's because the paper is a NIGHTMARE to get off. It's completely messed up my nail as I had to scrape against the edges to get it started, and then it continually ripped when I peeled it, meaning I had to start over again.There were no instructions for how to set it up or what order the panels should go in, they just toss the pieces at you and tell you to figure it out. This is probably fine if you're just trying to make something from scratch and know the intricacies of how this works; for me, though, it sucked. I literally just wanted a small monitor for an idle type game I like to play and want to have on screen and a nice case for it to be safe in.I would have figured a case like this would include a screen protector (you know, like most cases for electronic devices with screens?) but it didn't.It also didn't even fit the screen I'm trying to use it with. Or maybe it did, but they decided to skip any kind of instructions, so I have zero chance of knowing how to make it work.Either way, waste of money.

I bought this to use for my 7 Inch Raspberry Pi Screen Touchscreen Monitor 1024x600. I read in the reviews that no instructions were included so I searched online to find an assembly video and I did. I followed the video and the assembly was fairly easy but some of the screws were too long but not overly long. The stands that this kit came with did not fit properly so I did without since the 7 Inch Raspberry Pi came with its own stand. While not perfect it is better than leaving the back of the Raspberry pi exposed.

Looks well made but does not work with either touch screen i ordered. Need the very basic display for this to work with.

This fits the Longruner 7" screen perfectly. Assembly is a bit of a puzzle, but you just need to stop and think and plan a bit. It also looks like a few reviewers were mystified by having to peel the protective layer off of the acrylic. The acrylic is a glossy black with no markings whatsoever. I'm not using the supplied feet, but I did try them out and they were stable. It looks like you have a couple of mounting options for the feet. The pieces were cut out nice and no jagged edges or gauging.Not bad at all for $11

Worked perfectly with my Hoysond 7" 1024x600 touchscreen display. My only issue was that they left the acrylic cutting paper attached, which took a while to peel off.