PGONE Dynamic Sequential Blink LED Side Mirror Turn Signal Light Strip Assembly White Light Parking Puddle Light Lamp Kit For Infiniti Q50 Q60 Q70 QX30

The media could not be loaded. It looks great in the end. The wiring is a bit tricky. You have to take the whole side mirror assembly off and the door panel. Wiring in the end is somewhat quick and easy. Get self tapping screws for a small diameter wire you will need them if you want a string and direct connection. For the lights.

The media could not be loaded. Slight gap that allows rain to get in but other than that it fits great and looks good easy to install

READ ME if you have fitment issues!Overall cool upgrade, and price is great! BUT... on one side they put WAY too much clear silicone between the front and rear housing, that caused the back housing to bulge out. I noticed because the inside tab lined up well to the mirror assembly, but the outside tab was sticking out a half inch. I compared the assemblies and figured out what was wrong. I had to spend about an hour slowly and carefully grinding away the black plastic housing on the back until I could get it to fit properly. If I had installed it as it was, there would have been a big gap between the mirror assembly and the mirror cap. Pretty frustrating.I would have just returned it for another set, but hate popping off the mirror caps (tabs break, etc). Didn't wanna have to pop on the mirror cover again (or drive without it for 2 days) till the replacement come in.One side took about 10 minutes (mostly just taping off mirror housing and prying it off), but the other defective side took well over an hour.

It's very difficult to install, it takes hours, it takes even longer to install it on a night light.

Easy install, Everything was plug and play. There’s a review here that says its not 100% not but it most definitely can be. With the help of Speed Culture Studios Youtube video on the install. One side took about 2 hours, the passenger took 30 minutes. Very fast when you get your bearings. If you do NOT want to splice and do all that crap with wires then do this. With the extra wires in the box, take off the female connector using pliers. Twist and turn till you’re able to pull the wires out of the female connector making it 100% plug and play.

The media could not be loaded. I owned this product for about 6 months and they worked beautifully for the time being and out of nowhere my left side starts glitching. thinking its a bad ground i hunt every connection and made sure its good. started it up and same problem persists. I wish they kept up with their “waterproof” design

This will give your car an eye catching custom look. Just put them in, and already have people asking me where I got them. Thanks for making these available.A word of caution - Pay attention to the seller recommendation to have a professional installation done. If you are not experienced / confident working with late model car electrical systems and detail trim removals, pay to have these installed. Whatever it costs will look like a bargain if you break something or burn out an electrical circuit. You have to completely remove the mirrors and disassemble the base to fish the wires through to the door. Then figure out what to hook them up to with no instructions.TL;DR - Looks Great - Hard to Install

Besides the mini gap at the end great lights, easy to installI connected the blue and white cables into the purple/violet cable inside the door panel and there were no issues. I initially tried the white puddle light into the brown cable but it blew the fog light fuse so I just put both in the violet.The black cable I connected to the gray cable.