ArducamAuto Focus Camera, Autofocus for Raspberry Pi Camera Module, Motorized Focus Lens, OV5647 5MP 1080P

Great camera for your 3d printer. I just added one to my ender’s z gantry.

It was working fine. Good picture quality and control of the focus. After using it for about 6 months it stopped working. Would not recommend.

The camera works as expected. It is a module with motorized focus, not an autofocus camera (in this this was not clear).I only use it to adjust the focus once in a while and I had it only for a short time.The setup steps of the existing octoprint plugins are not described properly, so some digging was needed, however this has nothing to do with the camera module.

The product was acquired with the view it would add to the range of equipment available to me for various uses, but it failed with less than one hour of use, to say I was disappointed would be putting it mildly.

単体のカメラより少し高いだけですが、アクリルのスタンドと電動フォーカスが付いているので、お得感があります。Raspberry Pi 3BとRaspberry Pi 4Bの両方で動作しました。使い方は、添付のマニュアル通り（但し、英語！）です。Pythonでプログラムを実行すれば、オートフォーカスやキーボードでマニュアルフォーカスできました。（OpenCVとI2Cの設定に注意！）なお、スタンドの組み立て方は書かれていません。裏表、左右が分からないので、正直、難しいです。写真を見ながら頑張って組み立てて下さい。（ネジとボルトは余ります！）