AFM SafecoatSafe Seal Gallon

We raised the floor on a sunken room and the top boards are OSB plywood. We found out afterwards that these boards release a lot of VOCs and the smell was overwhelming and nauseating to me. We discovered this product and got it from Amazon right away.After one coat the smell was gone. Note that the product has its own smell, which is gone the next day. We had ordered enough for two coats so we just went ahead and put the other coat on, but I think one would have been enough.A one gallon jug of the stuff covered about 300 square feet of our boards. We used a window squeegee to spread on the first coat after pouring small amounts in puddles around the boards. But the second coat we used a garden pump-type sprayer to put the stuff on and used the squeegee to spread it an that worked better.

Bought this to stop faameldihide smell in our camper. Didn't work. I'm writing a review 4 years later because we finally found something that cuts the smell. Rug Doctor carpet cleaner. We have tried many things and We accidentally ran into this. It's the first thing that has ever cut the smell of that faameldihide.

This product applies easily and dries quickly. I sealed the particle board shelving that were out-gassing toxic fumes, which smelled like formaldehyde, that had been stinking up my garage.

This stuff is hard to work with, very thin, and the areas we used it on, now smell like it instead of the MDF-formaldehyde we were trying to cover.

We used this product to eliminate/reduce the offgas from kitchen cabinets in the new house we bought. We applied this product on all reachable plywood and other composite, untreated surfaces. We applied Acri-laq from the same manufacturer on some of the treated/lacquered surfaces. We also did 'bakeouts' by raising the HVAC temperature to 85+ degrees for eight hours or longer several nights, followed by early morning ventilation. These measures effectively eliminated nearly all of the new-house smell and make it habitable to us who are very sensitive to odors and offgas of all kinds.

i bought this to put over raw plywood i used for ceiling in my home.it makes me feel much safer knowing I have cut out most of the VOC's as well as dust.

Used this sealer to seal in formaldehyde fumes from plywood. Did a great job, we have chemical sensitivity.

I waited and applied three times on the board, no reduction in VOC smell.No use, waste of money.